Escalade ESV RWD V8-6.2L (2010)
5. Install the left wheelhouse liner. Refer to Front Wheelhouse Liner Replacement - Left Side (See: Body and Frame/Fender/Front Fender/Front
Fender Liner/Service and Repair/Front Wheelhouse Liner Replacement - Left Side).
6. Lower the vehicle.
7. Install the engine mount to frame bolts (1) and tighten the bolts to 65 Nm (48 lb ft) starting with the middle bolt then either side bolt.
8. Install the generator bracket. Refer to Generator Bracket Replacement (See: Starting and Charging/Charging System/Alternator/Service and
Repair/Generator Bracket Replacement).
9. If the vehicle is equipped with 4WD, install the front drive axle. Refer to Differential Carrier Assembly Replacement (9.25 inch) (See:
Transmission and Drivetrain/Differential Assembly/Service and Repair)Differential Carrier Assembly Replacement (8.25 inch) (See:
Transmission and Drivetrain/Differential Assembly/Service and Repair).
10. Lower the vehicle.
11. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement (See: Tune-up and Engine Performance Checks/Air
Cleaner Housing/Air Cleaner Fresh Air Duct/Hose/Service and Repair/Air Cleaner Resonator Outlet Duct Replacement).
Engine Mount Replacement - Right Side (1500 w/RPO LY2)
Engine Mount Replacement - Right Side (1500 w/RPO LY2)
Removal Procedure
Caution: When raising or supporting the engine for any reason, do not use a jack under the oil pan, any sheet metal, or the crankshaft pulley. Due to the
small clearance between the oil pan and the oil pump screen, jacking against the oil pan may cause the pan to be bent against the pump screen. This will
result in a damaged oil pickup unit.
