Escalade ESV RWD V8-6.2L (2010)
5. Install the fuel pipe bracket to the bellhousing stud.
6. Install the fuel pipe bracket nut.
Tighten the nut to 20 Nm (15 lb ft).
7. Lower the vehicle.
8. Remove the caps from the fuel rail and EVAP line.
9. Connect the EVAP line (1) quick connect fitting to the chassis line. Refer to Plastic Collar Quick Connect Fitting Service (See: Fuel Line
Coupler/Service and Repair/Plastic Collar Quick Connect Fitting Service).
10. Connect the fuel feed line (2) quick connect fitting to the fuel rail. Refer to Metal Collar Quick Connect Fitting Service (See: Fuel Line
Coupler/Service and Repair/Metal Collar Quick Connect Fitting Service).
11. Install the fuel fill cap.
12. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
Cable/Negative/Service and Repair/Battery Negative Cable Disconnection and Connection).
13. Use the following procedure in order to inspect for leaks: