Escalade ESV RWD V8-6.2L (2010)
4. Remove the rear axle vent hose clip from the fill pipe neck.
5. Loosen the fuel tank fill hose clamp (1) at the front tank.
6. Disconnect the fuel fill hose evaporative emission (EVAP) line quick connect fitting (2) from the fuel tank line. Refer to Plastic Collar Quick
Connect Fitting Service (See: Fuel Line Coupler/Service and Repair/Plastic Collar Quick Connect Fitting Service).
7. Remove the fuel fill hose from the front tank.
8. Remove the fuel fill hose integral clamp from the crossmember.
9. Remove the fuel fill hose/pipe assembly.
10. Cap the open end of the fuel tank in order to prevent fuel system contamination.
11. Cap the open ends of the fuel/EVAP lines in order to prevent fuel/EVAP system contamination.
12. If replacing any serviceable part of the fill pipe assembly proceed to the disassemble procedure, otherwise proceed to the installation procedure.
Disassemble
*
Evaporative emission canister hose (1)
*
Evaporative emission canister hose clamp (2)
*
Fuel tank fill pipe clamp (3)
*
Fuel tank fill pipe housing bolts (4)
