Escalade ESV RWD V8-6.2L (2010)
*
Evaporative emission canister hose (1)
Installation Procedure
1. Remove the caps from the open end of the front fuel tank.
2. Remove the caps from the fuel/EVAP lines.
3. Install the fuel fill hose/pipe assembly.
4. Install the fuel fill hose to the front tank.
5. Connect the fuel fill hose EVAP line quick connect fitting (2) to the fuel tank line. Refer to Plastic Collar Quick Connect Fitting Service (See:
Fuel Line Coupler/Service and Repair/Plastic Collar Quick Connect Fitting Service).
6. Tighten the fuel tank fill hose clamp (1) at the front tank.
Tighten the clamps to 2.5 Nm (22 lb in).
7. Install the fuel fill hose integral clamp to the crossmember.
8. Install the rear axle vent hose clip to the fill pipe neck.