Escalade ESV RWD V8-6.2L (2010)
3. If not equipped with active fuel management, perform the following step, using J 41712 or equivalent. Install the oil pressure sensor (706) and
washer (707).
4. Connect the engine harness electrical connector (1) to the oil pressure sensor. Tighten the sensor to 35 Nm (26 lb ft).
5. Install the intake manifold. Refer to Intake Manifold Replacement (Without AFM) (See: Engine, Cooling and Exhaust/Engine/Intake
Manifold/Service and Repair)Intake Manifold Replacement (With AFM) (See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and
Repair).
