Escalade ESV RWD V8-6.2L (2010)
3. Place a pipe wrench on the flats on the steering gear rack (1) next to the steering linkage inner tie rod (2).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Tighten the steering linkage inner tie rod (2).
Tighten the steering linkage inner tie rod to 150 Nm (111 lb ft).
5. Install the steering gear boot. Refer to Steering Gear Boot Replacement (HP2) (See: Steering Gear)Steering Gear Boot Replacement (Without
HP2) (See: Steering Gear).