Escalade ESV RWD V8-6.2L (2010)
Note: Ensure that the retaining ring is fully and evenly seated in the groove.
7. Install the retaining ring into the groove.
Note: Ensure that the outer bearing assembly rotates freely in the hub
8. Using the J 24426 - installer (2) and the J 8092 - handle (1), turn the rear axle hub over and seat the outer bearing assembly against the retaining
ring.
9. Turn the rear axle hub over and install the inner bearing cup.
10. Using the J 24427 - installer (2) and the J 8092 - handle (1), install the inner bearing cup into the wheel hub.