Escalade ESV RWD V8-6.2L (2010)
1. Position the wheel stud in the rear axle hub.
2. Using washers and a wheel nut, tighten the wheel nut until the wheel stud is fully seated in the rear axle hub.
3. Remove the lug nut and the washers.
4. Lubricate the following with a light coat of high melting point EP bearing lubricant:
*
The outer wheel bearing
*
The inner wheel bearing
*
The outer wheel bearing cup
*
The inner wheel bearing cup
*
The axle hub spindle
5. Install the outer bearing into the rear axle hub.
Note: Drive the outer bearing cup into the wheel hub until it is just past the retaining ring groove. Do not bottom out the bearing assembly in the
bore.
6. Using the J 44419 - installer (2) and the J 8092 - handle (1), install the outer bearing cup into the rear axle hub.
