Escalade V8-5.7L VIN R (2000)
Tailgate Release Handle: Service and Repair
Endgate Handle Replacement (Utility)
Endgate Handle Replacement (Utility)
Removal Procedure
1. Lower the endgate.
2. Remove the trim panel.
3. Remove the latch assembly cover from the endgate.
4. Remove the two bolts and the washers from the back of the endgate behind the handle assembly.
Raise the endgate.
5. Remove the handle assembly (2) by prying gently.
6. Remove the latch operating rods (4) from the clips on the handle by pushing the rods back.
7. Remove the handle assembly from the endgate.
Installation Procedure
1. Install the handle assembly (2) into the endgate.
2. Install the latch operating rods (4) into the clips on the handle.
Lower the endgate.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the two bolts and the washers onto the handle assembly from the back of the endgate.
Tighten the endgate to handle bolts to 4 N.m (35 lb in).
4. Install the latch assembly cover to the endgate.
The cover must be installed with both of the gates closed for proper alignment.
5. Install the endgate trim panel.
