Escalade V8-5.7L VIN R (2000)
Important: Do not use a hammer to install the camshaft sprocket onto the camshaft. To do so may dislodge the expansion cup plug (camshaft rear
bearing hole) and/or damage the camshaft.
6. Rotate the camshaft until the camshaft and crankshaft sprocket alignment marks are in the proper position.
Notice: Refer to Fastener Notice in Service Precautions.
7. Install camshaft sprocket bolts.
-
Tighten the camshaft sprocket bolts to 25 Nm (18 ft. lbs.).
Important: Align the keyway on the crankshaft position sensor reluctor ring with the woodruff key (crankshaft balancer) in the crankshaft, and install
the crankshaft position sensor reluctor ring onto the crankshaft until completely seated against the crankshaft sprocket.
8. Install the crankshaft position sensor reluctor ring.
8.1.
Align the keyway on the crankshaft position sensor reluctor ring with the woodruff key (crankshaft balancer) in the crankshaft.
8.2.
Use the J 5590 in order to push the crankshaft position sensor reluctor ring onto the crankshaft until completely seated against the
crankshaft sprocket.
