Escalade V8-5.7L VIN R (2000)
19. Remove the screw (2).
20. Remove the module assembly (2).
Ask an assistant for help in removing the module assembly, if necessary.
21. Remove the seven screws in order to remove the cover plate (8) on the bottom of the evaporator case from the module assembly.
22. Remove the heater core and the seal from the module assembly.
23. Remove the four screws in order to remove the case cover (6) of the evaporator from the module assembly.
24. Remove the evaporator core.
INSTALLATION PROCEDURE
1. Install the evaporator core.
If the evaporator core is being replaced, add oil.
Refer to Refrigerant Recovery and Recharging.
2. Install the four screws that hold the case cover (6) of the evaporator to the module assembly.
3. Install the heater core and the seal into the module assembly.
4. Install the seven screws that hold the cover plate (8) on the bottom of the evaporator case to the module assembly.
5. Install the module assembly (2).
Ask an assistant for help in installing the module assembly, it necessary.
6. Install the screw (1).
