Escalade V8-5.7L VIN R (2000)
33. Place a power source, 12V minimum/2 A minimum (i.e., a vehicle battery) near the shorted end of the passenger side deployment harness.
34. Separate the two ends of the inflatable restraint IP module deployment harness wires.
35. Connect the inflatable restraint IP module deployment harness wires to the power source in order to deploy the inflatable restraint IP module.
36. Disconnect the inflatable restraint IP module deployment harness wires from the power source.
37. Move the power source, 12 V minimum/2 A minimum (i.e., a vehicle battery) near the shorted end of the driver side deployment harness.
38. Separate the two ends of the inflatable restraint steering wheel module deployment harness wires.
39. Connect the inflatable restraint steering wheel module deployment harness wires to the power source in order to deploy the inflatable restraint
steering wheel module.
40. Disconnect the inflatable restraint steering wheel module deployment harness wires from the power source.
41. Twist together one end of each wire on the driver deployment harness in order to short the wires.
42. Twist together one end of each wire on the passenger deployment harness in order to short the wires.
43. Remove the drop cloth from the vehicle.
44. Disconnect both harnesses from the vehicle.
45. Discard the harnesses.
46. Scrap the vehicle in the same manner as a non-SIR equipped vehicle.
47. If one or both of the inflator modules did not deploy, perform the following steps to remove the undeployed module(s) from the vehicle:
