Escalade V8-5.7L VIN R (2000)
1. Route the hose in the same position the hose occupied prior to removal.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the power steering gear inlet hose (4) to the power steering pump.
-
Tighten the power steering gear inlet hose (4) at the power steering pump to 27 Nm (20 ft. lbs.).
3. Install the power steering gear inlet hose (4) to the power steering gear.
-
Tighten the power steering gear inlet hose (4) at the power steering gear to 27 Nm (20 ft. lbs.).
4. Remove the drain pan from under the vehicle.
5. Bleed the power steering system. Refer to Bleeding Power Steering System.
Power Steering Gear Outlet Hose With Vacuum Brake Booster
Notice: Refer to Power Steering Hose Disconnected Notice in Service Precautions.
Notice: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation easier.
Failure to follow these procedures could result in component damage.
Removal Procedure
