Escalade V8-5.7L VIN R (2000)
1. Install a drain pan under the vehicle.
2. Siphon the power steering fluid from the reservoir to prevent excessive spillage.
3. Remove the hydraulic brake booster outlet hose (1) from the power steering pump.
4. Remove the hydraulic brake booster outlet hose (1) from the power steering gear.
5. Remove the hydraulic brake booster outlet hose from the vehicle.
Installation Procedure
1. Route the hose in the same position the hose occupied prior to removal.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the hydraulic brake booster outlet hose (1) to the power steering gear.
-
Tighten the hydraulic brake booster outlet hose (1) at the power steering gear to 27 Nm (20 ft. lbs.).
3. Position the clamp on the pump end of the hydraulic brake booster outlet hose.
4. Install the hydraulic brake booster outlet hose (1) to the power steering pump.
-
Tighten the clamp on the hydraulic brake booster outlet hose. Fully crimp the clamp until zero gap between both halves is achieved prior to
spring back.
5. Remove the drain pan from under the vehicle.
6. Bleed the power steering system. Refer to Bleeding Power Steering System.
