Escalade V8-5.7L VIN R (2000)
Suspension Strut / Shock Absorber: Service and Repair
Front Suspension
Shock Absorber Replacement
Removal Procedure
Notice: Original equipment shock absorbers serve additionally as suspension drop cutoffs. Replacement shock absorbers must have a built in
suspension cutoff feature and must not be longer than original shocks when they are fully extended or serious vehicle or component damage could
result.
1. Raise the vehicle on a hoist.
2. Remove the lower nut, the washer, and the bolt. Collapse the shock absorber.
3. Remove the upper nut, the washer, and the bolt.
4. Remove the shock absorber.
Installation Procedure
1. Install the shock absorber to the bracket.
2. Install the bolts. Fit the bolts in the direction shown.
Notice: Refer to Fastener Notice in Service Precautions.
3. Install the new nuts and the washers to the bolts.
-
Tighten the upper and the lower nut to 90 Nm (66 ft. lbs.).
4. Lower the vehicle.
Shock Absorber Disposal
Caution: Gas charged shock absorbers contain high pressure gas. Do not remove the snap ring from inside me top of the tube. If the snap ring is
