Escalade V8-5.7L VIN R (2000)
Transfer Case Actuator: Service and Repair
NVG 243-NP1 (Two Speed Selectable)
Removal Procedure
1. Remove the transfer case shield. Refer to Shield Replacement
2. Remove the transfer case wiring harness connectors from the motor/encoder.
3. Remove the four bolts that secure the motor/encoder to the transfer case.
Installation Procedure
1. Install the with a motor/encoder.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the four bolts securing the motor/encoder to the transfer case.
Tighten the motor/encoder bolts to 25 Nm (18 ft. lbs.).
^
Remove all gasket material remaining from the motor/encoder.
^
Ensure the motor/encoder aligns properly with the transfer case interior shifting components.
^
Align the motor/encoder mating surface detent with the transfer case mating surface detent.