Escalade V8-5.7L VIN R (2000)
2. Use a soft spray in order to water test the stationary window immediately.
3. Using warm water is preferred in order to accelerate the cure of adhesive.
4. Do not direct a hard stream of high pressure water at fresh urethane adhesive.
30. Inspect the stationary window for leaks.
31. If any leaks are found, use a plastic paddle in order to apply extra urethane at the leak point.
32. Retest stationary window for leaks.
Important: Use the following procedure in order to properly cure the urethane adhesive.
*
Allow the vehicle to remain at room temperature (21°C or 70°F) at 30 percent relative humidity.
*
Allow a minimum of 6 hours for the moisture curing urethane adhesive.
*
Allow a minimum of 1 hour to 1 1/2 hours for the chemical curing urethane adhesive.
*
Partially lower a door window in order to prevent pressure buildups when closing doors before the urethane adhesive cures.
*
Do not drive the vehicle until the urethane adhesive is fully cured.
Do not use compressed air in order to dry the urethane adhesive.
34. Remove the tape from the painted surfaces.
35. Install the rear quarter trim panel.
