Escalade V8-5.7L VIN R (2000)
4. Clean around the edge of the inside surface of the windshield with a
Installation Procedure
Caution: When replacing stationary windows, use Urethane Adhesive Kit GM P/N 12346392 (Canadian P/N 10952983), or a urethane adhesive
system meeting GM Specification GM3651G, to maintain original installation integrity. Failure to use the urethane adhesive kit will result in
poor retention of the window which may allow unrestrained occupants to be ejected from the vehicle resulting in personal injury.
After repairing the opening as indicated, perform the following:
1. Shake the pinchweld primer (black #3) for at least one minute.
Caution: Failure to prep the area prior to the application of primer may cause insufficient bonding of urethane adhesive. Insufficient
bonding of urethane adhesive may allow unrestrained occupants to be ejected from the vehicle resulting in personal injury.
2. Use a new dauber to apply the pinchweld primer (black #3) to the surface (1) of the bonding area.
3. Allow the primer to dry for approximately 10 minutes. Ensure that all nicks and scratches are covered.
4. If using extended method, install the spacers and the VIN plate filler strip.
5. Install the reveal molding to the edge of the windshield. If the original reveal molding is damaged it must be replaced.
6. Install a new acoustic strip if needed.
