Escalade V8-6.0L VIN N (2002)
1. Install the cable clips (1) to the A-pillar.
2. Connect the electrical wire connector (4).
3. Connect the cable (3) to the radio.
4. Install the cable clips (1) to the roof.
5. Connect the cable (2) to the radio antenna module.
6. Connect the wire connector to the radio antenna module.
NOTE: Refer to Fastener Notice in Service Precautions.
7. Install the bolt retaining the radio antenna module to the roof.
Tighten
Tighten the retaining bolt to 9 N.m (80 lb in).
8. Install the headliner.
9. Install the IP trim panel.
