Escalade V8-6.0L VIN N (2002)
Tape Player: Description and Operation
Uplevel/Luxury
1. Tapes may be played with the ignition ON or OFF. If the ignition is ON but the radio is OFF, the tape will begin playing.
A tape symbol, accompanied by tape direction arrows, is shown in the center of the graphic display whenever a tape is playing.
2. Tapes are end-loaded into these players. Insert the tape squarely through the door, exposed tape side of the cassette facing the right.
3. When the tape is fully inserted, the AM/FM portion of the radio will turn OFF and the tape will begin playing.
4. The tape player works best with tapes that are 30 to 45 minutes long on each side. Longer tapes may not work well in the cassette player because
the tapes are so thin.
5. To load a cassette with the ignition in the OFF position, press EJECT or RECALL.
6. Insert the cassette.
7. If the ignition is in the ON position and the radio is in the OFF position, the tape will begin to play.
8. The player automatically senses the tape cartridge for metal or Cr02 tape media and presets the pre-emphasis.
For metal tapes, "DD" will be displayed.
9. Any time a tape is playing, use the volume, balance, fade, treble, and bass just as with the radio.
An arrow indicates which side of the tape is being played.
10. When you insert a tape, the top of the cassette plays first.
PREV
^
Press the PREV or the SEEK left arrow push button in order to search for the previous selection. The tape direction arrow blinks during SEEK
operation.
^
A minimum 3 second blank gap is required for proper operation.
^
Audio is muted during SEEK.
PROG
Press the PROG push button in order to switch from one side of the tape to the other.
NEXT
^
Press the NEXT or the SEEK right arrow push button in order to search for the next selection
^
A minimum of a 3 second gap is required for the player to stop at the beginning of a selection.
^
The tape direction arrow will blink during the SEEK operation.
REV
^
Press REV in order to rewind the tape. The tape rapidly reverses to the beginning of the cassette or until you press the REV push-button a second
time.
The radio plays the last selected station during the REV operation.
^
The tape direction arrow blinks during REV operation.
DOLBY(R)
Dolby Noise Reduction is manufactured under a license from Dolby Laboratories Licensing Corporation. Dolby(R) and the "DD" symbol are
trademarks of Dolby Laboratories Licensing Corporation.
1. Press the Dolby push-button in order to reduce cassette tape noise.
2. The "DD" Dolby(R) symbol will appear in the display.
FWD
1. Press FWD in order to fast-forward the tape. The tape rapidly advances to the end of the tape or until you press the FWD push-button again.
2. The radio will play the last selected station during the FWD operation.
3. The tape direction arrow blinks during FWD operation.
AM-FM
Press the AM-FM button in order to switch from tape to radio.
TAPE AUX
1. Press TAPE AUX in order to return to the tape player.
2. The lighted arrow appears and shows the direction of play when a tape is in the active mode.
EJECT
1. In order to remove the tape, press EJECT.
2. EJECT may be activated with either the ignition or the radio OFF.
3. Cassettes may be loaded with the radio OFF by pressing EJECT before loading the cassette tape.
CLN
1. It CLN appears on the display, the cassette player needs to be cleaned in order to prevent damage to the tape player.
2. After cleaning the tape player, press and hold EJECT for 5 seconds in order to reset the CLN indicator.
3. The radio displays "- - - "in order to show that the indicator reset.
