Escalade V8-6.0L VIN N (2002)
Parking Assist Control Module: Service and Repair
Utility
REMOVAL PROCEDURE
1. Lift the right rear seating surface up to gain access to the rear parking aid module.
2. Disconnect the electrical connector from the module.
3. Remove the module retainer.
4. Remove the module from the seat frame.
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Install the module to the seat frame.
Tighten
Tighten the module retainer to 1.7 N.m (15 lb in).
2. Connect the electrical connector.
3. Lower the seating surface.
