Escalade V8-6.0L VIN N (2002)
1. Connect the electrical connectors, if necessary.
2. Align the retainers with the holes in the door.
3. Install the trim panel to the door by lowering the trim panel down into the retainer holes in order to seat the retainers.
NOTE: Refer to Fastener Notice in Service Precautions.
4. Install the trim panel screws.
Tighten
Tighten the trim panel screws to 2 N.m (18 lb in).
5. Install the manual lock lever by pressing the lever until the lever is completely seated.
6. Install the window-regulator handle, if necessary.
7. Install the door handle bezel.
Tahoe, Yukon, Escalade
REMOVAL PROCEDURE
1. Remove the door handle bezel.
2. Remove the window-regulator handle, if equipped.
3. Remove the manual lock lever from the trim panel using a flat-bladed tool.
4. Remove the trim panel screws.
5. In order to remove the trim panel, slide the trim panel upward and outward in order to release the trim panel tab retainers.
6. Disconnect the electrical connectors, if necessary.
INSTALLATION PROCEDURE
