Escalade V8-6.0L VIN N (2002)
4. Attach the seat trim cover to the seat cushion frame.
5. Install the lumbar actuator (5).
6. Install the seat switch bezel.
7. Place the cushion on the rear plastic holders (1) on the underside of the seat cushion, and push rearward.
8. Connect the lumbar cable to the underside of the seat cushion (6). Connect the lumbar wire harness (if equipped with power lumbar).
9. Connect the electrical connectors.
Notice: Refer to Fastener Notice in Service Precautions.
10. Install the front nuts (2) onto the studs on the underside of the cushion.
Tighten the nuts to 21 N.m (15 lb ft).
11. Feed the seat belt through the seat cushion.
