Escalade V8-6.0L VIN N (2002)
Notice: Refer to Fastener Notice in Cautions and Notices.
8. Install the coolant heater in place of the drain plug.
-
Tighten the coolant heater to 50 Nm (37 ft. lbs.).
9. Push the engine coolant heater cord electrical connector (2) firmly into the coolant heater (1).
Important: The engine coolant heater cord must not touch the engine, hot pipes, manifold, or any moving parts. Always keep the electrical cord
neatly rolled up with the end of the cord tucked in the center of the coil and secured in place
10. Place the cord into position.
Notice: The heater cord must not touch the engine, hot pipes, manifold, or any moving parts. Route the cord to the left front of the engine
compartment securing with tie straps as necessary to prevent damage.
11. Install the heater cord bolt and retainer.
-
Tighten the heater cord bolt to 8 Nm (71 inch lbs.).
