Escalade V8-6.0L VIN N (2002)
8. Remove the right fuel rail cover.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the right fuel rail cover.
-
Tighten the bolts to 9 Nm (80 inch lbs.)
2. Install the surge tank/heater hoses to the clip on the right fuel rail cover.
3. Install the left fuel rail cover.
-
Tighten the bolts to 9 Nm (80 inch lbs.)
4. Install the sight shield retainer and the bolts, if required.
-
Tighten the retainer bolts to 5 Nm (44 inch lbs.).
Notice: Use care when installing the engine sight shield to avoid contacting the manifold absolute pressure (MAP) sensor wire harness connector.