Escalade V8-6.0L VIN N (2002)
10. Install the PCV hose with valve.
11. If equipped with vacuum assisted brakes, install the vacuum brake booster hose to the rear of the intake manifold.
12. If equipped, position a new EGR pipe gasket on the exhaust manifold.
13. If equipped, install the EGR pipe with valve.
14. If equipped, install the following EGR pipe bolts until snug:
-
Intake manifold (1)
-
Cylinder head (2)
-
Exhaust manifold (3)
15. If equipped, tighten the EGR pipe bolts.
-
Tighten the EGR valve pipe-to-intake manifold bolts to 10 Nm (89 inch lbs.).
-
Tighten the EGR valve pipe-to-cylinder head bolts to 50 Nm (37 ft. lbs.).
-
Tighten the EGR valve pipe-to-exhaust manifold bolts to 30 Nm (22 ft. lbs.).
16. Route the electrical harness into position over the engine.