Escalade V8-6.0L VIN N (2002)
8. Install the exhaust muffler nuts, until snug.
9. Tighten the exhaust pipe clamp bolt and muffler nuts.
-
Tighten the exhaust muffler nuts to 40 Nm (30 ft. lbs.).
-
Tighten the exhaust pipe clamp to 40 Nm (30 ft. lbs.).
10. If equipped with a 6.01- engine, perform the following:
-
Connect the oxygen sensor electrical connector.
-
Connect the CPA retainer.
-
Clip the oxygen sensor connector to the frame.
11. Connect the oxygen sensor electrical connector.
12. Connect the CPA retainer.
13. Clip the oxygen sensor connector to the support.
