Escalade V8-6.0L VIN N (2002)
1. Remove the right rear quarter trim panel.
2. Disconnect the electrical connector from the mode actuator (1).
3. Remove the retaining screws from the mode actuator.
4. Remove the mode actuator (1) from the vehicle.
INSTALLATION PROCEDURE
1. Install the mode actuator (1) to the vehicle.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the screws to the mode actuator (1).
Tighten
Tighten the screws to 1.6 N.m (14 lb in).
3. Connect the electrical connector to the mode actuator.
4. Install the left rear quarter trim panel.
Mode Actuator Replacement (Delphi)
REMOVAL PROCEDURE