Escalade V8-6.0L VIN N (2002)
^
Number 30 and 87 should have RED wires in their cavities.
^
Number 86 should have a PPL wire.
^
Number 85 should be a BLK wire.
24.
Measure 51 mm (2 in) from the base of the relay connector and place a wrap of electrical tape around the PPL and the RED wires, and then a
couple wraps around the conduit (make it look like it did when you started).
25.
Remove the relay-mounting bracket from the relay.
26.
Place the relay-mounting bracket in a vise and straighten out the two 90 degree bends so that the bracket is straight.
27.
Reinstall the bracket into the relay with the protruding bumps against the relay.
28.
Remove the key from the lock cylinder.
29.
Open the hood and install fender covers.
30.
Remove the upper radiator baffle.
31.
Remove the grille.
32.
Remove the left fender to radiator core support brace.
33.
Remove the left fender to cowl support.
34.
Remove the battery and battery tray.
35.
Remove the underhood electrical center covers.
36.
Loosely install the bolt, which held the fender to radiator support, through the relay bracket and into the radiator support from which the bolt was
removed.
37.
Route the RED and PPL wires from the relay down to and under the PCM to frame bracket, along side the main harness and up to the right side of
the underhood electrical center.
38.
Lift the underhood electrical center and disconnect the Black C2 connector from the bottom of the underhood electrical center.
39.
Locate the GRN wire in the underhood electrical center connector C2.
^
2000-2002 models, Cavity B3.
^
2003 models, Cavity A3.
40.
Cut and remove the tie strap from around the wires of which the GRN wire is bundled.
^
2000-2002 models, Cavity B3.
^
2003 models, Cavity A3.
41.
Remove the CPA for this section of the C2 connector.
42.
Remove the terminal for the GRN wire from connector C2.
^
2000-2002 models, Cavity B3.
^
2003 models, Cavity A3.
43.
Cut the terminal from the GRN wire removed from Connector C2.
^
2000-2002 models, Cavity B3.
^
2003 models, Cavity A3.
