Escalade V8-6.0L VIN N (2002)
17. Route the deployment harness out of the vehicle's driver side.
18. Disconnect the LF side impact module connector (1) from the vehicle wiring harness (2) located under the LF seat.
19. Cut the LF side impact module harness connector out of the vehicle leaving at least 16 cm (6 in) of wire at the connector.
20. Strip 13 mm (0.5 in) of insulation from each of the LF side impact module connector wire leads.
21. Cut 26.1 m (20 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. Use these wires to fabricate the deployment harness.
