Escalade V8-6.0L VIN N (2002)
Installation Procedure
1. Install the control module (1) to the vehicle.
2. Connect the wiring harness (2) to the control module (3).
Important: If you are replacing the module, you must program the module by performing the following procedure.
^
Connect the scan tool to the Data Link Connector (DLC).
^
Turn the ignition ON with the engine OFF. Select the SPECIAL FUNCTIONS for the RTD module on the scan tool.
^
Select the Recalibration line under SPECIAL FUNCTIONS and follow the instructions on the scan tool to complete the RTD module
programming.
^
After completion of programming, return to SPECIAL FUNCTIONS on the scan tool, select ALC Trimset and follow the instructions displayed to
perform the ALC trimset.
3. Install the cover (1) to the vehicle.
