Escalade V8-6.0L VIN N (2002)
6.
Trim the excess Teflon(R) tape from the inner-most threads. Excessive Teflon(R) tape may enter the front axle assembly possibly causing a seal
leak.
7.
Reinstall the vent/plug connector 0-ring.
Important:
Do not over or under-tighten from this specification or a leak may occur.
8.
Install the vent/plug connector back into the axle assembly.
Tighten
Tighten the vent/plug connector to 15-20 N.m (11-14 lb ft).
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer