Escalade 4WD V8-6.0L Hybrid (2011)
17. Position the engine wiring harness (electronic throttle control branch) as necessary.
18. Install the engine wiring harness (electronic throttle control branch) clip to the ignition coil bracket stud.
19. Connect the engine harness electrical connector (1) to the ignition coil wire harness.
20. Install the CPA retainer (2).
21. Position the generator control module 3 phase cables to the bracket channel.
22. Install the generator control module 3 phase cable clip to the tab (3) on the engine bracket (2).
23. Install the generator control module 3 phase cable clip nut (1).
Tighten the nut to 9 Nm (80 lb in).
24. Enable the high voltage system. Refer to High Voltage Enabling See: Hybrid Drive Systems/Service and Repair/Procedures/High Voltage
Enabling.
25. Install the intake manifold cover. Refer to Upper Intake Manifold Sight Shield Replacement See: Intake Manifold/Service and Repair/Upper
Intake Manifold Sight Shield Replacement.