Escalade 4WD V8-6.0L Hybrid (2011)
4. For 2500 series vehicles, raise the differential carrier into position.
5. Install the differential carrier left side upper bolt and nut until snug.
6. Install the differential carrier left side lower bolt and nut until snug.
7. Install the differential carrier right side nuts and tighten to 100 Nm (74 lb ft).
8. For 1500 series vehicles, raise the differential carrier into position.
9. Install the differential carrier right side nuts.
10. Install the differential carrier left side bolts and tighten to 100 Nm (74 lb ft).
11. If equipped, install the engine protection shield. Refer to Engine Shield Replacement See: Body and Frame/Frame/Skid Plate/Service and
Repair/Engine Shield Replacement.
12. Remove the jack or utility stand from the rear of the vehicle.
13. Lower the vehicle.
