Escalade 4WD V8-6.0L Hybrid (2011)
1. Install the dash panel exhaust heat shield (1 or 3) to the dash panel studs.
Caution: Refer to Fastener Caution See: Service Precautions/Vehicle Damage Warnings/Fastener Caution.
2. Install the dash panel exhaust heat shield nuts (2 or 4) and tighten to 9 Nm (80 lb in).
3. Install the catalytic converter, if required. Refer to one of the following:
*
Catalytic Converter Replacement See: Catalytic Converter/Service and Repair/Catalytic Converter Replacement
*
Three-Way Catalytic Converter Replacement See: Catalytic Converter/Service and Repair/Three-Way Catalytic Converter Replacement
4. For 2500 series vehicles, position the oil pan skid plate and tighten until snug the 2 rear oil pan skid plate bolts. Install the 2 front oil pan skid plate
bolts, if equipped and tighten the bolts to 28 Nm (21 lb ft)