Escalade 4WD V8-6.0L Hybrid (2011)
3. Connect the engine wiring harness electrical connector (7) to the HO2S.
4. Install the engine wiring harness electrical connector clip (6) to the fuel line clip.
5. Install the CPA retainer (4).
6. Install the front propeller shaft to the front differential, if equipped with 4WD. Refer to Front Propeller Shaft Replacement See: Transmission and
Drivetrain/Drive/Propeller Shafts, Bearings and Joints/Drive/Propeller Shaft/Service and Repair/Front Propeller Shaft Replacement.
7. Lower the vehicle.