Escalade 4WD V8-6.0L Hybrid (2011)
1. Install the ignition lock cylinder case (1) to the vehicle.
Caution: Refer to Fastener Caution See: Service Precautions/Vehicle Damage Warnings/Fastener Caution.
2. Install the 3 ignition lock cylinder case screws (2).
Tighten the screws to 7 Nm (62 lb in).
3. Install the park lock cable into the lock cylinder housing.
4. Connect the passlock and key buzzer to the ignition lock cylinder case.
5. Install the ignition/start switch. Refer to Ignition and Start Switch Replacement See: Service and Repair.
6. Install the inflatable restraint steering wheel module coil. Refer to Steering Wheel Inflatable Restraint Module Coil Replacement See: Restraint
Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Removal and Replacement.