Escalade 4WD V8-6.0L Hybrid (2011)
5. Install the axle shaft seal using the J 21128 .
6. Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
7. Install the axle shaft. Refer to Rear Axle Shaft Replacement See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Axle Shaft/Service and Repair.
8. Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement .
9. Install the rear wheel speed sensor. Refer to Rear Wheel Speed Sensor Replacement See: .
10. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation See: Maintenance/Wheels and Tires/Service and Repair.
11. Fill the rear axle. Refer to Differential Oil Replacement .
12. Lower the vehicle.