Escalade 4WD V8-6.0L Hybrid (2011)
Installation Procedure
1. Apply sealant to the threads of the NEW oil pressure sensor. Refer to Adhesives, Fluids, Lubricants, and Sealers See: Engine, Cooling and
Exhaust/Engine/Specifications/Adhesives, Fluids, Lubricants, and Sealers.
Caution: Refer to Fastener Caution See: Service Precautions/Vehicle Damage Warnings/Fastener Caution.
2. Using J 41712 or equivalent, install the oil pressure sensor (706) and washer (707).
Tighten the sensor to 35 Nm (26 lb ft).
3. Connect the engine harness electrical connector (1) to the oil pressure sensor.
Tighten the sensor to 35 Nm (26 lb ft).
