Escalade 4WD V8-6.0L Hybrid (2011)
6. Disconnect the engine wiring harness electrical connector (4) from the oil level sensor.
Caution: Avoid cable and wiring damage. DO NOT suspend the starter by the cables or wires attached to the solenoid terminals. Use a rope or
mechanics wire to suspend the starter.
7. Slide the starter forward until the starter clears the transmission and properly support the starter.
8. Lower the vehicle half way.
9. Remove the right front wheel and tire. Refer to Tire and Wheel Removal and Installation See: Maintenance/Wheels and Tires/Service and Repair.
10. Working through the right wheel well opening, remove the engine wiring harness lead nut (1).
11. Remove the engine wiring harness lead terminal (2) from the starter.
12. Remove the starter solenoid cable clip bolt (2) from the frame.
