Escalade 4WD V8-6.0L Hybrid (2011)
9. Position the starter into place.
10. Install the starter bolts.
Tighten the starter bolts to 50 Nm (37 lb ft).
11. Install the right front wheel and tire. Refer to Tire and Wheel Removal and Installation See: Maintenance/Wheels and Tires/Service and Repair.
12. Raise the vehicle.
13. Connect the engine wiring harness electrical connector (4) to the oil level sensor.
14. Install the transmission cover bolt.
Tighten the cover bolt to 9 Nm (80 lb in).
15. Install the oil pan skid plate if equipped, Refer to Oil Pan Skid Plate Replacement .
16. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection See: Battery/Battery Cable/Negative/Service
