Escalade 4WD V8-6.0L Hybrid (2011)
Tools Required
*
J 6278 Pitman Shaft Bearing Remover and Installer
*
J 6219 Pitman Shaft Oil Seal Installer
*
J 4245 Internal Snap Ring Pliers
Disassembly Procedure
1. Remove the steering gear. Refer to Steering Gear Replacement .
2. Remove the steering gear pitman shaft and housing cover. Refer to Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle
See: Steering Gear Pitman Shaft and Housing Cover Replacement - Off Vehicle.
3. Remove the pitman arm (4) from the steering gear (1). Refer to Pitman Arm Replacement See: Pitman Arm/Service and Repair.
4. Remove the pitman arm boot (3) from the steering gear housing (1).
Important: Do not score the steering gear housing bore when prying out the seals and washers.
5. Remove the dust seal (2) from the steering gear housing (1).
6. Remove the steering gear pitman shaft seal retaining ring (2) from the steering gear housing (1) using pliers J 4245 .
7. Remove the steering gear pitman shaft washer (3) from the steering gear housing (1).
8. Pry the steering gear pitman shaft seal (2) from the steering gear housing (1) using a screwdriver.
9. Inspect the housing for burrs and replace if necessary.