Escalade 4WD V8-6.0L Hybrid (2011)
*
The pinion bearings
*
The pinion seal
*
The carrier bearings
*
The axle bearings
*
The axle seals
10. Scribe an alignment line between the pinion shaft and the pinion yoke.
11. Install the J 8614-01 onto the pinion as shown.
12. Remove the pinion nut while holding the J 8614-01 .
13. Install the J 8614-2 (2) and the J 8614-3 (3) into the J 8614-01 (1) as shown.
14. Remove the pinon yoke by turning the J 8614-3 (3) clockwise while holding the J 8614-01 (1).
Note: Carefully remove the oil seal from the bore. Do not distort or scratch the aluminum case.
15. Remove the oil seal using a suitable seal removal tool.
Installation Procedure
