Escalade AWD V8-6.0L Hybrid (2010)
34. Install the engine harness clip (4) to the ignition coil bracket stud.
35. Connect the engine harness electrical connectors (3) to the left side fuel injectors.
36. Connect the engine harness electrical connector (2) to the ignition coil harness electrical connector.
37. Install the CPA retainer (1).
38. Connect the engine wiring harness electrical connector (3) to the MAP sensor.
39. Connect the engine harness electrical connector (2) to the EVAP canister purge solenoid.
40. Install the engine harness retainer to the stud and locator pin.
41. Install the engine harness retainer nut (1).
Tighten the nut to 5 Nm (44 lb in).
42. Install the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement (See: Tune-up and Engine Performance Checks/Air
Cleaner Housing/Air Cleaner Fresh Air Duct/Hose/Service and Repair).
43. Connect the battery ground cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
Cable/Negative/Service and Repair/Battery Negative Cable Disconnection and Connection).
44. Perform the High Voltage Service connect. Refer to High Voltage Enabling (See: Hybrid Drive Systems/Battery System, Hybrid Drive/Testing
