Escalade AWD V8-6.0L Hybrid (2010)
Drive Motor Control Module: Service and Repair
Drive Motor Generator Control Module Sight Shield Replacement
Drive Motor Generator Control Module Sight Shield Replacement
Removal
1. Remove the fender brace. Refer to Front Fender Rear Upper Bracket Replacement (See: Body and Frame/Fender/Front Fender/Service and
Repair/Front Fender Rear Upper Bracket Replacement).
Note: Removing the sight shield disengages the High Voltage Interlock Circuit (HVIC). The sight shield mounting fastener must be installed and
properly tightened for the HVIC to be closed. Failure to properly tighten the sight shield mounting fastener may result in an open HVIC condition
and DTCs.
2. Loosen the sight shield mounting fastener (1) and lift the sight shield from the ball studs (2).
Danger: Always perform the High Voltage Disabling procedure prior to servicing any High Voltage component or connection. Personal
Protection Equipment (PPE) and proper procedures must be followed.
The High Voltage Disabling procedure will perform the following tasks:
*
Identify how to disable high voltage.
*
Identify how to test for the presence of high voltage.
*
Identify condition under which high voltage is always present and personal protection equipment (PPE) and proper procedures must
be followed.
Failure to follow the procedures exactly as written may result in serious injury or death.
3. Perform the High Voltage Disabling procedure. Refer to High Voltage Disabling (See: Battery System, Hybrid Drive/Testing and
Inspection/Initial Inspection and Diagnostic Overview/High Voltage Disabling).
Installation
