Escalade AWD V8-6.0L Hybrid (2010)
4. Install the adjustment arm (2) in the support assembly (1).
5. Install the adjuster bolt (3) and the adjustment nut (4).
6. Slide the torsion bar rearward until the torsion bar is fully seated in the adjustment arm.
7. Install the J 36202 on the adjustment arm and the support assembly.
8. Using the J 36202, increase the tension on the adjustment arm in order to load the torsion bar.
9. Align the reference marks, turn the adjuster bolt the same amount of turns as it took to remove it.
10. Remove the J 36202 from the support assembly.
11. Remove the safety stand and lower the vehicle.
12. Measure the Z height. Refer to Trim Height Inspection (See: Testing and Inspection/Component Tests and General Diagnostics/Trim Height
Inspection).
