Escalade AWD V8-6.2L (2009)
No parts are required for this program.
Service Procedure
Do not attempt to order the calibration number from GMSPO. The calibration numbers required for this service procedure are programmed into control
modules via a Multiple Diagnostic Interface (MDI) or Tech 2(R) scan tool and TIS2WEB with the calibration update. Use TIS2WEB on or after
05/15/09 to obtain the calibration. If you cannot access the calibration, call the Techline Customer Support Center and it will be provided.
For step-by-step programming instructions, please refer to SI and the Techline Information System (TIS) terminal.
1. Verify that there is a battery charge of 12 to 16 volts. The battery must be able to maintain a charge during programming. Only use an approved
Midtronic 165-PSC charger to maintain proper battery voltage during programming.
2. Reprogram the body control module (BCM). Refer to SI and Service Programming System (SPS) documentation for programming instructions, if
required.
1. Connect the MDI or Tech 2(R) to the vehicle.
Important
Select J2534 MDI or J2534 Tech 2(R) and Reprogram ECU from the Select Diagnostic Tool and Programming Process screen. The
J2534 MDI will reprogram the module in less time than the Tech 2(R) scan tool. DO NOT choose "Tech 2 Legacy Pass-Thru".
2. Select BCM Body Control Module from the Supported Controllers screen.
3. Follow the on-screen instructions.
3. Using the MDI or Tech 2(R), clear all DTCs if required.
Courtesy Transportation - For US and Canada
The General Motors Courtesy Transportation program is intended to minimize customer inconvenience when a vehicle requires a repair that is covered
by the New Vehicle Limited Warranties. The availability of courtesy transportation to customers whose vehicles are within the warranty coverage period
and involved in a product program is very important in maintaining customer satisfaction. Dealers are to ensure that these customers understand that
shuttle service or some other form of courtesy transportation is available and will be provided at no charge. Dealers should refer to the General Motors
Service Policies and Procedures Manual for Courtesy Transportation guidelines.
Claim Information
Submit a Product Claim with the information indicated below:
Refer to the General Motors WINS Claims Processing Manual for details on Product Recall Claim Submission.
Customer Notification - For US and Canada
General Motors will notify customers of this program on their vehicle (see copy of customer letter included with this bulletin).
Customer Notification - For Export
Letters will be sent to known owners of record located within areas covered by the US National Traffic and Motor Vehicle Safety Act. For owners
outside these areas, dealers should notify customers using the attached sample letter.
Dealer Program Responsibility
All unsold new vehicles in dealers' possession and subject to this program must be held and inspected/repaired per the service procedure of this program
bulletin before customers take possession of these vehicles.
Dealers are to service all vehicles subject to this program at no charge to customers, regardless of mileage, age of vehicle, or ownership, through June
30, 2010.
