Escalade AWD V8-6.2L (2009)
13. Remove the CMP sensor (703).
14. Remove the CMP actuator magnet bolts (751), and magnet (752).
15. Remove and discard the CMP actuator magnet gasket (753).
Installation Procedure
Note:
*
Do not reuse the crankshaft oil seal or front cover gasket.
*
Do not apply any type of sealant to the front cover gasket, unless specified.
*
The special tool in this procedure is used to properly center the front crankshaft front oil seal.
-
All gasket surfaces should be free of oil or other foreign material during assembly.
-
The crankshaft front oil seal MUST be centered in relation to the crankshaft.
-
An improperly aligned front cover may cause premature front oil seal wear and/or engine oil leaks.
