Escalade AWD V8-6.2L (2009)
1. Install the ignition lock cylinder case (1) to the vehicle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the 3 ignition lock cylinder case screws (2).
Tighten the screws to 7 Nm(62 lb in).
3. Install the park lock cable into the lock cylinder housing.
4. Connect the passlock and key buzzer to the ignition lock cylinder case.
5. Install the ignition/start switch. Refer to Ignition and Start Switch Replacement (See: Service and Repair).
6. Install the inflatable restraint steering wheel module coil. Refer to Steering Wheel Inflatable Restraint Module Coil Replacement (See: Restraint
Systems/Air Bag Systems/Clockspring Assembly / Spiral Cable/Service and Repair/Removal and Replacement).
Ignition Lock Cylinder Replacement
Ignition Lock Cylinder Replacement
Removal Procedure
Warning: Refer to SIR Warning (See: Restraint Systems/Service Precautions/SIR Warning).
1. Disable the SIR system. Refer to SIR Disabling and Enabling (See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument Panel/Air
Bag(s) Arming and Disarming/Service and Repair).
2. Remove the steering column shroud. Refer to Steering Column Shroud Replacement (Without Electronic Tilt Steering) (See: Steering and
Suspension/Steering/Steering Column/Service and Repair/Steering Column Shroud Replacement (Without Electronic Tilt Steering))Steering
Column Shroud Replacement (With Electronic Tilt Steering) (See: Steering and Suspension/Steering/Steering Column/Service and
Repair/Steering Column Shroud Replacement (With Electronic Tilt Steering)).
3. With the key installed hold it in the START position.