Escalade ESV AWD V8-6.2L (2007)
3.
Remove the door trim panel. Refer to SI.
4.
Remove the window garnish molding. Refer to SI.
5.
Remove the inner door glass belt strip.
6.
Remove the window channel weatherstrip from the channel.
7.
Inspect the window channel retaining clips. The clips should be fully engaged through the flange.
8.
Install tape around the window channel and flange. Do the complete opening from front to rear. The tape should only extend 14 mm (1/2 in.) in
height on the inboard flange so it can't be seen when the garnish molding is installed. The illustration above shows how the tape should look when
installing.
9.
Install the window channel weatherstrip.
10.
Install the inner door glass belt strip.
11.
Install the window garnish molding. Refer to SI.
12.
Install the door trim panel. Refer to SI.
13.
Install the upper extension trim panel.
